Chapter 10 Home Networking
AX/DX/EX/PX Series User’s Guide
216
The following table describes the fields in this screen.
Table 55 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name This displays the name of the group that your Zyxel Device belongs to.
LAN IP Setup
IP Address Enter the LAN IP address you want to assign to your Zyxel Device in dotted decimal notation,
for example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your Zyxel Device automatically computes the subnet mask based on the
IP address you enter, so do not change this field unless you are instructed to do so.
IGMP Snooping
See Section 15.1 on page 287 for more information on IGMP snooping.
Active Select Enable to allow the Zyxel Device to passively learn multicast group.
IGMP Mode Select Standard Mode to forward multicast packets to a port that joins the multicast group
and broadcast unknown multicast packets from the WAN to all LAN ports.
Select Blocking Mode to block all unknown multicast packets from the WAN.
DHCP Server State
DHCP Select Enable to have your Zyxel Device assign IP addresses, an IP default gateway and DNS
servers to LAN computers and other devices that are DHCP clients.
If you select Disable, you need to manually configure the IP addresses of the computers and
other devices on your LAN.
If you select DHCP Relay, the Zyxel Device acts as a surrogate DHCP server and relays DHCP
requests and responses between the remote server and the clients.
When DHCP is used, the following fields need to be set:
IP Addressing Values
The IP Addressing Values fields appear only when you select Enable in the DHCP field.
Beginning IP
Address
This field specifies the first of the contiguous addresses in the IP address pool.
Ending IP Address This field specifies the last of the contiguous addresses in the IP address pool.
Auto reserve IP for
the same host
Enable this if you want to reserve the IP address for the same host.
DHCP Server Lease Time
This is the period of time DHCP-assigned addresses is used. DHCP automatically assigns IP addresses to clients when
they log in. DHCP centralizes IP address management on central computers that run the DHCP server program.
DHCP leases addresses, for a period of time, which means that past addresses are “recycled” and made available
for future reassignment to other systems.
This field is only available when you select Enable in the DHCP field.
Days/Hours/Minutes DHCP server leases an address to a new device for a period of time, called the DHCP lease
time. When the lease expires, the DHCP server might assign the IP address to a different
device.
DNS Values
This field appears only when you select Enable in the DHCP field.
To Next Page
Loading...
