ZyXEL Communications DX3301-T0 - Page 220

Chapter 10 Home Networking
AX/DX/EX/PX Series User’s Guide
220
The following table describes the labels in this screen.
If you click Static DHCP Configuration in the Static DHCP screen, the following screen displays. Using a
static DHCP means a client will always have the same IP address assigned to it by the DHCP server.
Assign a fixed IP address to a device by selecting the interface group of this device and its IP address
type and selecting the device/computer from a list or manually entering its MAC address and assigned
IP address.
Figure 123 Network Setting > Home Networking > Static DHCP: Static DHCP Configuration
The following table describes the labels in this screen.
Table 56 Network Setting > Home Networking > Static DHCP
LABEL DESCRIPTION
Static DHCP
Configuration
Click this to configure a static DHCP entry.
# This is the index number of the entry.
Status This field displays whether the client is connected to the Zyxel Device.
MAC Address The MAC (Media Access Control) or Ethernet address on a LAN (Local Area Network) is
unique to your computer (six pairs of hexadecimal notation).
A network interface card such as an Ethernet adapter has a hardwired address that is
assigned at the factory. This address follows an industry standard that ensures no other
adapter has a similar address.
IP Address This field displays the IP address relative to the # field listed above.
Modify Click the Edit icon to configure the connection.
Click the Delete icon to remove the connection.
Table 57 Network Setting > Home Networking > Static DHCP: Static DHCP Configuration
LABEL DESCRIPTION
Active Select Enable to activate static DHCP in your Zyxel Device.
Group Name The Group Name is normally Default.
IP Type The IP Type is normally IPv4 (non-configurable).
Select Device Info Select between Manual Input which allows you to enter the next two fields (MAC Address
and IP Address); or selecting an existing device would show its MAC address and IP address.
MAC Address Enter the MAC address of a computer on your LAN if you select Manual Input in the previous
field.