Chapter 11 Routing
AX/DX/EX/PX Series User’s Guide
244
Figure 145 Network Setting > Routing > Policy Route: Add or Edit
The following table describes the labels in this screen.
Table 69 Network Setting > Routing > Policy Route: Add or Edit
LABEL DESCRIPTION
Active Click this to enable (turns blue) activation of the policy route. Otherwise, click to disable (turns
gray).
Route Name Enter a descriptive name of up to eight printable English keyboard characters, not including
spaces.
Source IP
Address
Enter the source IP address.
Source Subnet
Mask
Enter the source subnet mask address.
Protocol Select the transport layer protocol (TCP, UDP, or None).
Source Port Enter the source port number.
Source MAC Enter the source MAC address.
Source Interface
(example: br0 or
LAN1 – LAN4)
Type the name of the interface from which the matched traffic is sent.
WAN Interface Select a WAN interface through which the traffic is sent. You must have the WAN interfaces
already configured in the Broadband screens.
Cancel Click Cancel to exit this screen without saving.
OK Click OK to save your changes.
To Next Page
Loading...
