Chapter 37 Remote Management
AX/DX/EX/PX Series User’s Guide
388
Figure 243 Maintenance > Remote Management > MGMT Services
The following table describes the fields in this screen.
Table 156 Maintenance > Remote Management > MGMT Services
LABEL DESCRIPTION
Service Control
WAN Interface
used for services
Select Any_WAN to have the Zyxel Device automatically activate the remote management
service when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the Zyxel Device
activate the remote management service when the selected WAN connections are up.
WWAN Enable the WWAN (cellular) connection configured in Network Setting > Broadband > Cellular
Backup to access the service on the Zyxel Device.
ETHWAN Enable the Ethernet WAN connection configured in Network Setting > Broadband > Ethernet
WAN to access the service on the Zyxel Device.
Service This is the service you may use to access the Zyxel Device.
LAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the LAN.
WLAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from all WAN connections.
Trust Domain Select the Enable check box for the corresponding services that you want to allow access to the
Zyxel Device from the trusted host IP address.
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the Zyxel Device.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
