Chapter 42 Firmware Upgrade
AX/DX/EX/PX Series User’s Guide
405
The following table describes the labels in this screen.
After you see the firmware updating screen, wait a few minutes before logging into the Zyxel Device
again.
Figure 254 Firmware Uploading
The Zyxel Device automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Table 164 Maintenance > Firmware Upgrade
LABEL DESCRIPTION
Upgrade Firmware
Restore
Default
Settings After
Firmware
Upgrade
Select this to enable this option that restores the factory-default to the Zyxel Device after
upgrading the firmware. Otherwise, make sure this is clear if you do not want the Zyxel Device
to lose all its current configurations and return to the factory defaults.
Note: Make sure to backup the Zyxel Device’s configuration settings first in case the
restore to factory-default process is not successful. Refer to Section 43.2 on
page 407.
Current
Firmware
Version
This is the current firmware version.
File Path Type in the location of the file you want to upload in this field or click Choose File/Browse to find
it.
Choose File/
Browse
Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to 3 minutes.
Upgrade WWAN Package
Current
WWAN
Package
Version
This is the current version or the WWAN (Wireless Wide Area Network) package installed in the
Zyxel Device. A WWAN package adds support for more 4G USB dongles without you having to
upgrade the Zyxel Device’s firmware.
File Path Type in the location of the file you want to upload in this field or click Choose File/Browse to find
it.
Choose File/
Browse
Click this to find the .bin file you want to upload. Remember that you must decompress
compressed (.zip) files before you can upload them.
Upload Click this to begin the upload process. This process may take up to 3 minutes.