ZyXEL Communications DX5301-B3 - Configuring a MAC Address Filter

Chapter 5 Tutorials
AX/DX/EX/PX Series User’s Guide
104
5.5.3 Configuring a MAC Address Filter
You can use a MAC address filter to exclusively allow or permanently block someone from the WiFi
network.
This example shows that computer B is not allowed access to the WiFi network.
Figure 55 Configure a MAC Address Filter Example
1 Go to the Security > MAC Filter > MAC Filter screen. Under MAC Address Filter, select Enable.
2 Click Add New Rule to add a new entry. Select Active, and then enter the Host Name and MAC Address
of computer B. Click Apply.