Chapter 10 Home Networking
AX/DX/EX/PX Series User’s Guide
224
10.6 STB Vendor ID
Use this screen to configure the Vendor IDs of connected Set Top Boxes (STBs) so the Zyxel Device can
automatically create static DHCP entries for them when they request IP addresses.
Click Network Setting > Home Networking > STB Vendor ID to open this screen.
Figure 126 Network Setting > Home Networking > STB Vendor ID
The following table describes the labels in this screen.
IPv4 Address Enter the public IP address provided by your ISP.
Subnet Mask Enter the public IPv4 subnet mask provided by your ISP.
Offer Public IP
by DHCP
Click this switch to enable or disable the Zyxel Device to provide public IP addresses by DHCP
server. When the switch goes to the right , the function is enabled. Otherwise, it is not.
Enable ARP
Proxy
Click this switch to enable or disable the ARP (Address Resolution Protocol) proxy. When the
switch goes to the right , the function is enabled. Otherwise, it is not.
Cancel
Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 59 Network Setting > Home Networking > Additional Subnet (continued)
LABEL DESCRIPTION
Table 60 Network Setting > Home Networking > STB Vendor ID
LABEL DESCRIPTION
Vendor ID 1 – 5 These are STB’s Vendor Class Identifiers (DHCP option 60). A Vendor Class Identifier is usually
used to inform the DHCP server a DHCP client’s vendor and functionality.
Cancel
Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
To Next Page
Loading...
