ZyXEL Communications DX5301-B3 - Add New Rule

Chapter 20 MAC Filter
AX/DX/EX/PX Series User’s Guide
318
The following table describes the labels in this screen.
20.2.1 Add New Rule
You can choose to enable or disable the filters per entry; make sure that the check box under Active is
selected if you want to use a filter, as shown in the example below. Select Security > MAC Filter > Add
New Rule. The screen appears as shown.
Figure 195 Security > MAC Filter > Add New Rule
The following table describes the labels in this screen.
Table 111 Security > MAC Filter
LABEL DESCRIPTION
MAC Address Filter Select Enable to activate the MAC filter function.
MAC Restrict Mode Select Allow to only permit the listed MAC addresses access to the Zyxel Device. Select
Deny to permit anyone access to the Zyxel Device except the listed MAC addresses.
Add New Rule Select an existing WiFi or wired LAN client from the list to add as a new entry. Select Custom
if you want to manually enter the Host Name and MAC Address.
Click the Add button to create a new entry.
Set This is the index number of the MAC address.
Active Select Active to enable the MAC filter rule. The rule will not be applied if Allow is not
selected under MAC Restrict Mode.
Host Name Enter the host name of the WiFi or wired LAN clients that are allowed access to the Zyxel
Device.
MAC Address Enter the MAC addresses of the WiFi or wired LAN clients that are allowed access to the
Zyxel Device in these address fields. Enter the MAC addresses in a valid MAC address
format, that is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Delete Click the Delete icon to delete an existing rule.
Cancel Click Cancel to restore your previously saved settings.
Apply Click Apply to save your changes.
Table 112 Security > MAC Filter > Add New Rule
LABEL DESCRIPTION
Set This is the index number of the MAC address.
Active Select Active to enable the MAC filter rule. The rule will not be applied if Allow is not
selected under MAC Restrict Mode.
Host Name Enter the host name of the WiFi or wired LAN clients that are allowed access to the
Zyxel Device.
MAC Address Enter the MAC addresses of the WiFi or wired LAN clients that are allowed access to
the Zyxel Device in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.
Delete Click the Delete icon to delete an existing rule.