ZyXEL Communications DX5301-B3 - Setting up a Non-Mpro Mesh Router and Mpro Mesh Extender with a Wired Connection

Chapter 6 App Tutorials
AX/DX/EX/PX Series User’s Guide
120
3 Change the default SSID and WiFi key on the MPro Mesh Router; see Section 6.4 on page 115 for more
information. After applying changes, you will need to reconnect to the MPro Mesh Router again using
the new SSID and WiFi key.
4 Use WPS to copy the SSID and WiFi key from the MPro Mesh Router to the MPro Mesh Extender.
5 Turn off the MPro Mesh Extender and place it where you need to extend WiFi coverage. Use the app to
see if the extender is too far from the router; see Section 6.5 on page 117 for more information.
l
6.6.2 Setting up a non-MPro Mesh Router and MPro Mesh Extender with a
Wired Connection
This scenario describes the process to create an MPro Mesh network with a wired connection from the
non-MPro Mesh router to two extenders.
Make sure the non-MPro Mesh router is connected to the Internet. The first extender must be connected
to your router using an Ethernet cable. Then, connect the second extender wirelessly to the first Zyxel
Device