Chapter 8 Broadband
AX/DX/EX/PX Series User’s Guide
170
Figure 96 Network > Broadband > Cellular Backup (Budget Setup)
The following table describes the labels in this screen.
Table 39 Network Setting > Broadband > Cellular Backup
LABEL DESCRIPTION
General
Cellular Backup Click this switch to have the Zyxel Device use the cellular connection as your WAN or a backup
when the wired WAN connection fails. When the switch goes to the right , the function is
enabled. Otherwise, it is not.
Ping Check Click this switch to ping check the connection status of your WAN. When the switch goes to the
right , the function is enabled. Otherwise, it is not.
You can configure the frequency of the ping check and number of consecutive failures before
triggering cellular backup.
Check Cycle Enter the frequency of the ping check in this field.
Consecutive Fail Enter how many consecutive failures are required before cellular backup is triggered.
Ping Default
Gateway
Select this to have the Zyxel Device ping the WAN interface’s default gateway IP address.
To Next Page
Loading...
