AX/DX/EX/PX Series User’s Guide
386
Verify Password Type the new password again for confirmation.
Retry Times Enter the number of times consecutive wrong passwords can be entered for this account. 0
means there is no limit.
Idle Timeout Enter the length of inactive time before the Zyxel Device will automatically log the user out of the
Web Configurator.
Lock Period Enter the length of time a user must wait before attempting to log in again after a number of
consecutive wrong passwords have been entered as defined in Retry Times.
Group
Specify whether this user will have Administrator or User privileges. An Administrator account can
access all Web Configurator menus. A User account can only access Monitor and Maintenance
menus.
The maximum account number of Administrator and User are both four. The total number of the
users allowed to log in the Zyxel Device at the same time is eight.
The Administrator privileges are the following:
• Quick Start setup.
• The following screens are visible for setup:
Broadband, Wireless, Home Networking, Routing, NAT, DNS, Firewall, MAC Filter, Voice, Log,
Traffic Status, ARP Table, Routing Table, Cellular WAN Status, System, User Account, Remote
Management, Time, Email Notification, Log Setting, Firmware Upgrade, Backup/Restore,
Reboot, Diagnostic.
The User privileges are the following:
• The following screens are visible for setup:
Log, Traffic Status, ARP Table, Routing Table, Cellular WAN Status, User Account, Remote
Management, Time, Email Notification, Log Setting, Firmware Upgrade,
Backup/Restore,
Reboot, Diagnostic.
Remote
Privilege
Select whether this user can access the Zyxel Device with HTTP, Telnet or SSH through the WAN,
LAN or LAN/WAN. Only the Administrator is allowed to use Telnet and SSH for remote
management.
Cancel Click Cancel to restore your previously saved settings.
OK Click OK to save your changes.
Table 155 Maintenance > User Account > User Account Add (continued)
LABEL DESCRIPTION
To Next Page
Loading...
