Chapter 5 Tutorials
AX/DX/EX/PX Series User’s Guide
71
2 In this example, the DSL connection has the following information.
3 Enter the General and ATM PVC Configuration settings as provided above.
3a Set the Type to ADSL over ATM.
3b Choose the Encapsulation specified by your DSL service provider. For this example, the service
provider requires a username and password to establish an Internet connection. Therefore, select
PPPoE as the WAN encapsulation type.
3c Set the IPv4/IPv6 Mode to IPv4 Only.
4 Enter the account information provided by your DSL service provider.
5 Enable Apply as Default Gateway to use this rule as your default Internet connection. Then select Use
Following Static DNS Address and enter the DNS server addresses provided by your DSL service provider.
6 For the rest of the fields, use the default settings.
7 Click Apply to save your settings.
General
Name MyDSLConnection
Type ADSL over ATM
Connection Mode Routing
Encapsulation PPPoE
IPv6/IPv4 Mode IPv4
ATM PVC Configuration
VPI/VCI 36/48
Encapsulation Mode LLC/SNAP-Bridging
Service Category UBR without PCR
Account Information
PPP User Name 1234@DSL-Ex.com
PPP Password ABCDEF!
Static IP Address 192.168.1.32
Gateway IP Address 192.168.1.254
Primary DNS server 192.168.5.2
Secondary DNS server 192.168.5.1
Others Authentication Method: AUTO
PPPoE Passthrough: Disabled
NAT: Enabled
IGMP Multicast Proxy: Enabled
Apply as Default Gateway: Enabled
VLAN: Disabled
To Next Page
Loading...
