ES-3124 Series User’s Guide
198 Chapter 25 DiffServ Code Point
Figure 93 DiffServ
The following table describes the related labels you use to create a static route.
Table 61 Static Routing
LABEL DESCRIPTION
Diffserv Click this to return to the main DiffServ screen.
DSCP to
802.1p
Mapping
In this section you map each DSCP value with an 802.1p value in the drop down list
box.
0-63 This field displays each DSCP value.
802.1p Priority Use the drop down list box to select the IEEE 802.1p priority (0 to 7) to which you
would like to map this DSCP value.
Apply Click Apply to save your changes to the switch’s run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields.
To Next Page
Loading...
