ZyXEL Communications ES-3124 - Interface Port-Channel Commands; Table 87 Interface Port-Channel Commands

ES-3124 Series User’s Guide
Chapter 34 Introducing Commands 267
34.11.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
option
Allows the switch to add DHCP
relay agent information.
13
information
Allows the switch to add system
name to agent information.
13
diffserv
Enables DiffServ on the switch. 13
dscp <0-63> priority <0-7>
Maps DSCP value with an 802.1p
value.
13
pwr interface <port-
list>
Enables PoE (Power over
Ethernet) on the specified ports.
ES-3124PWR only.
13
usagethreshold
<1-99>
Sets the percentage of power
usage which initiates mib traps.
ES-3124PWR only.
13
mibtrap
Enables mib traps on the switch
(ES-3124PWR only). Traps are
initiated when the usage reaches
the limit set up by the
usagethreshold command.
Table 86 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 87 interface port-channel Commands
COMMAND DESCRIPTION PRIVILEGE
interface
port-
channel
<port-
list>
Enables a port or a list of ports for
configuration.
13
weight <wt1>
<wt2> ... <wt8>
Sets the interface to use WFQ
weighting. A weight value of one to
eight is given to each variable from
wt 1 to wt 8.
13
egress set
<port-list>
Sets the outgoing traffic port list for
a port-based VLAN.
13
igmp-immediate-
leave
Enables IGMP immediate leave on
the port.
13
igmp-filtering
profile <name>
Sets the IGMP filtering profile for
this port.
13
igmp-group-
limited
Limits the number of multicast
groups.
13
igmp-group-
limited number
<number>
Sets the number of multicast
groups this port is allowed to join.
13