ES-3124 Series User’s Guide
200 Chapter 26 Maintenance
26.2 Load Factory Default
Follow the steps below to reset the switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory Defaults
to clear all switch configuration information you configured and return to the factory
defaults.
2 The following message appears. Click OK to reset all switch configurations to the
factory defaults.
Figure 95 Load Factory Default: Start
3 Enter the user name and password to log in the web configurator again. Click OK.
Figure 96 Load Factory Default: Start
4 The following message appears. Click Ye s to close this window.
Save
Configuration
Click Config 1 to save the current configuration settings to Configuration 1 on the
switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the
switch.
Reboot
System
Click Config 1 to reboot the system and load Configuration 1 on the switch.
Click Config 2 to reboot the system and load Configuration 2 on the switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the switch.
Table 62 Maintenance (continued)
LABEL DESCRIPTION
To Next Page
Loading...
