ES-3124 Series User’s Guide
Chapter 35 User and Enable Mode Commands 281
Note: When you use the write memory command without specifying a configuration
file index number, the switch saves the changes to the configuration file the
switch is currently using.
35.6.2 Resetting to the Factory Default
Follow the steps below to reset the switch back to the factory defaults.
1 Enter
erase running config to reset the current running configuration.
2 Enter
write memory to save the changes to the current configuration file. If you want to
reset the second configuration file, use the
write memory command again with the
specified index number.
The following example resets both configuration files to the factory default settings.
sysname# erase running-config
sysname# write memory
sysname# write memory 2
To Next Page
Loading...
