ZyXEL Communications ES-3124 - Using Command History; Saving Your Configuration; Switch Configuration File

ES-3124 Series User’s Guide
Chapter 34 Introducing Commands 247
Enter <command> ? to display detailed help information about the sub commands and
parameters.
34.9 Using Command History
The switch keeps a list of recently used commands available to you for reuse. You can use any
commands in the history again by pressing the up (y) or down (z) arrow key to scroll through
the previously used commands and press
[ENTER]. Use the history command to display the list
of commands.
34.10 Saving Your Configuration
After you set the switch settings with the configuration commands, use the write memory
command to save the changes permanently.
Note: The
write memory command is not available in User mode.
You must save your changes after each CLI session. All unsaved configuration
changes are lost once you restart the switch.
34.10.1 Switch Configuration File
When you configure the switch using either the CLI (Command Line Interface) or web
configurator, the settings are saved as a series of commands in a configuration file on the
switch. You can perform the following with a configuration file:
• Back up switch configuration once the switch is set up to work in your network.
• Restore switch configuration.
sysname> ping ?
<ip|host-name> destination ip address
help Description of ping help
sysname>
sysname> history
enable
exit
show ip
history
sysname>
sysname# write memory