ZyXEL Communications ES-3124 - Figure 13 Transceiver Installation Example; Figure 14 Installed Transceiver; Figure 15 Opening the Transceivers Latch Example; Figure 16 Transceiver Removal Example

ES-3124 Series User’s Guide
Chapter 3 Hardware Overview 51
Figure 13 Transceiver Installation Example
2 Press the transceiver firmly until it clicks into place.
3 The switch automatically detects the installed transceiver. Check the LEDs to verify that
it is functioning properly.
Figure 14 Installed Transceiver
3.1.3.2 Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module).
1 Open the transceiver’s latch (latch styles vary).
Figure 15 Opening the Transceiver’s Latch Example
2 Pull the transceiver out of the slot.
Figure 16 Transceiver Removal Example