ZyXEL Communications ES-3124 - Name; Speed-Duplex; Test

ES-3124 Series User’s Guide
Chapter 37 Interface Commands 303
37.2.12 name
Syntax:
name <port-name-string>
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set a name for the ports.
37.2.13 speed-duplex
Syntax:
speed-duplex <auto|10-half|10-full|100-half|100-full|1000-full>
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the speed to 100 Mbps in half duplex mode.
37.2.14 test
You can perform an interface loopback test on specified ports. The test returns Passed! or
Failed!
<port-name-string>
= Sets a name for your port interface(s).
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# name Test
<auto|10-half|10-
full|100-half|100-
full|1000-full>
= Sets the duplex mode (half or full) and speed (10, 100 or 1000
Mbps) of the connection on the port. Selecting auto (auto-
negotiation) makes one port able to negotiate with a peer
automatically to obtain the connection speed and duplex mode
that both ends support.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# speed-duplex 100-half