13/100
www.zyxel.com
2.1.2 How to upgrade firmware from FTP?
Overview
Upgrade firmware by using File Transfer Protocol (FTP).
1. On the operating system open the Command Processor (CMD).
Figure 1 PC > Start > All Programs > Accessories > Command Prompt
2. Use a FTP client to access the switch>ftp (switch IP address)>Enter username &
password> put 430XXXX0C0.bin ras-0. Ras-0: firmware image 1. Ras-1: firmware
image 2. Ras: only for Switch model series with only single image.
Note: The firmware image (.bin file) should be in the same directory of the cmd
command page.
Figure 2
To Next Page
Loading...
