33/100
www.zyxel.com
4.1.1 How to configure RSTP on the switch?
Overview
The Switch uses IEEE 802.1w RSTP (Rapid Spanning Tree Protocol) that allows faster
convergence of the spanning tree than STP. In RSTP, there are additional port
roles; alternate port & backup port, and the port states are discarding, learning,
and forwarding.
Topology:
Note: In the scenario all switch have been configured with RSTP features the
elected root bridge is switch A with a lowest bridge priority and switch C port 1 is
the blocked port.
1. Select Rapid Spanning Tree then click Apply to run feature.
Figure 1 Advanced Application > Spanning Tree Protocol > Configuration
To Next Page
Loading...
