43/100
www.zyxel.com
4.2.1 How to configure Static Trunk on the switch?
Overview
Static trunks are groups of two to eight ports that act as single virtual links.
Static trunks are commonly used to improve network performance by increasing
the available bandwidth between the switch and other network devices as well
as to enhance the reliability of the connections between network devices.
1. In this screen activate trunk group T1, select the traffic distribution algorithm
used by this group and select the ports that should belong to this group as
shown in the figure below. Click Apply when you are done.
Figure 2, Advanced Application > Link Aggregation > Link Aggregation Setting
To Next Page
Loading...
