19/100
www.zyxel.com
3.1.2 How to configure Subnet Base VLAN on the switch?
Overview
Subnet based VLANs allow to group traffic into logical VLANs based on the source
IP subnet you specify.
Note: Subnet based VLAN applies to un-tagged packets and is applicable only
when you use IEEE 802.1Q tagged VLAN.
Subnet based VLAN topology,
Figure 1
Note: In the scenario, switch is configured with a three specify IP source subnet. It
divided with Data (192.168.1.0), Video (10.59.1.0) & Voice (172.25.1.0). With this
feature if the switch receives an IP address of 192.168.1.1, the device will know
that the traffic is Data traffic.
1. Check the Active box to activate the subnet-based VLAN, and then click
Apply.
Figure 2 Advanced Application > VLAN > VLAN Configuration > Subnet-based
VLAN
To Next Page
Loading...
