Chapter 15 System
NWA3000-N Series User’s Guide
214
1 Test whether the SSH service is available on the NWA3000-N series AP.
Enter “telnet 192.168.1.2 22” at a terminal prompt and press [ENTER]. The
computer attempts to connect to port 22 on the NWA3000-N series AP (using
the default IP address of 192.168.1.2).
A message displays indicating the SSH protocol version supported by the
NWA3000-N series AP.
Figure 98 SSH Example 2: Test
2 Enter “ssh –1 192.168.1.2”. This command forces your computer to connect to
the NWA3000-N series AP using SSH version 1. If this is the first time you are
connecting to the NWA3000-N series AP using SSH, a message displays prompting
you to save the host information of the NWA3000-N series AP. Type “yes” and
press [ENTER].
Then enter the password to log in to the NWA3000-N series AP.
Figure 99 SSH Example 2: Log in
3 The CLI screen displays next.
15.7 Telnet
You can use Telnet to access the NWA3000-N series AP’s command line interface.
Click Configuration > System > TELNET to configure your NWA3000-N series
AP for remote Telnet access. Use this screen to enable or disable Telnet and set
the server port number.
$ telnet 192.168.1.2 22
Trying 192.168.1.2...
Connected to 192.168.1.2.
Escape character is '^]'.
SSH-1.5-1.0.0
$ ssh –1 192.168.1.2
The authenticity of host '192.168.1.2 (192.168.1.2)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.2' (RSA1) to the list of known hosts.
Administrator@192.168.1.2's password:
To Next Page
Loading...
