Chapter 22 Product Specifications
NWA3000-N Series User’s Guide
282
22.1 Wall-Mounting Instructions
Complete the following steps to hang your NWA3000-N series AP on a wall.
Note: See Table 96 on page 279 for the size of screws to use and how far apart to
place them.
1 Select a position free of obstructions on a sturdy wall.
2 Drill two holes for the screws.
Be careful to avoid damaging pipes or cables located inside the
wall when drilling holes for the screws.
3 Do not insert the screws all the way into the wall. Leave a small gap of about 0.5
cm between the heads of the screws and the wall.
4 Make sure the screws are snugly fastened to the wall. They need to hold the
weight of the NWA3000-N series AP with the connection cables.
5 Align the holes on the back of the NWA3000-N series AP with the screws on the
wall. Hang the NWA3000-N series AP on the screws.
Figure 125 Wall-mounting Example
To Next Page
Loading...
