ZyXEL Communications NWA3000-N Series - Set the LAN IP Address and Management VLAN (Vlan99)

Chapter 4 Tutorials
NWA3000-N Series User’s Guide
57
4.1.1.1 Controller
1 Use the Configuration > MGNT MODE screen to set the NWA3000-N series AP
to controller mode.
2 The NWA3000-N series AP resets to its default settings for the controller mode
including the IP address of 192.168.1.2 and restarts. Wait a short while before you
attempt to log in again.
4.1.1.2 Managed APs
1 Log into the other NWA3000-N series APs and use the Configuration > MGNT
MODE screen to set them to be the managed APs using the Auto IP address
option so they obtain the controller’s IP address from the DHCP server.
2 Now you can no longer log into the web configurator of the managed NWA3000-N
series APs; you must manage the NWA3000-N series AP through the controller AP
on your network.
4.1.2 Set the LAN IP Address and Management VLAN (vlan99)
This section shows you how to set up the LAN IP address and the VLAN for
managing the controller. This is only for network administrators to manage the
controller.