Chapter 17 File Manager
NWA3000-N Series User’s Guide
244
• If there is a startup-config.conf, the NWA3000-N series AP checks it for errors
and applies it. If there are no errors, the NWA3000-N series AP uses it and
copies it to the lastgood.conf configuration file as a back up file. If there is an
error, the NWA3000-N series AP generates a log and copies the startup-
config.conf configuration file to the startup-config-bad.conf configuration
file and tries the existing lastgood.conf configuration file. If there isn’t a
lastgood.conf configuration file or it also has an error, the NWA3000-N series
AP applies the system-default.conf configuration file.
• You can change the way the startup-config.conf file is applied. Include the
setenv-startup stop-on-error off command. The NWA3000-N series AP
ignores any errors in the startup-config.conf file and applies all of the valid
commands. The NWA3000-N series AP still generates a log for any errors.
Figure 113 Maintenance > File Manager > Configuration File
Do not turn off the NWA3000-N series AP while configuration file
upload is in progress.
To Next Page
Loading...
