ZyXEL P-336M User’s Guide
53 Chapter 4 Advanced
The following table describes the labels in this screen.
4.6 Access Control
Internet access control allows you to create and enforce Internet access policies tailored to
your needs. Access control gives you the ability to block specified computers and/or
applications from accessing the Internet. You can also set a schedule for when the P-336M
performs content filtering.
Click Advanced > Access Control to display the configuration screen as shown.
Table 20 Advanced: Routing
LABEL DESCRIPTION
Add Route
Enable Select this option to activate this setting.
This field is not applicable for pre-defined routes.
Destination IP Enter the destination IP address in dotted decimal notation.
Netmask Enter the subnet mask.
Gateway Enter the IP address of the gateway device for the selected interface below.
Interface Select an interface to which you want to apply the setting.
Metric Metric represents the “cost” of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
Save Click Save to save the settings.
Clear Click Clear to start configuring this part of the screen again.
Routes List
Enable Select this option to activate this rule. Clear this check box to disable this rule
without deleting it.
Destination IP This field displays the destination IP address.
Netmask This field displays the subnet mask for the destination IP address above.
Gateway This field displays the IP address of the gateway device.
Metric This field displays the “cost” of this route.
Interface This field displays the interface to which this routing setting is applied.
To Next Page
Loading...
