ZyXEL Communications USG210 - Test the Ipsec VPN Tunnel

131/749
www.zyxel.com
Test the IPSec VPN Tunnel
Go to ZyWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click
Connect on the upper bar. The Status connect icon is lit when the interface is
connected.
Hub_HQ > CONFIGURATION > VPN > IPSec VPN > VPN Connection
Spoke_Branch_A > CONFIGURATION > VPN > IPSec VPN > VPN Connection
Spoke_Branch_B > CONFIGURATION > VPN > IPSec VPN > VPN Connection
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up Time
and the Inbound(Bytes)/Outbound(Bytes) traffic. Click Connectivity Check to
verify the result of ICMP Connectivity.
Hub_HQ > MONITOR > VPN Monitor > IPSec > Hub_HQ-to-Branch_A