ZyXEL Communications USG210 - Set up the Bridge Interface on the Zywall;Usg

671/749
www.zyxel.com
Set Up the Bridge Interface on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Bridge > add
Bridge, select Interface Type to be the general type, select Zone to be the LAN
zone. In the Member Configuration, select internal server (IntServer1 interface in
this example) and public IP address (Public WAN interface in this example) to be in
the same member group.
In the IP Address Assignment section, select Used Fixed IP Address and configure
br1 IP address (172.124.163.150/24 in this example).
CONFIGURATION > Network > Interface > Bridge > add Bridge