ZyXEL Communications USG210 - How to Configure L2 TP VPN with Android 5.0 Mobile Devices

256/749
www.zyxel.com
How to Configure L2TP VPN with Android 5.0 Mobile
Devices
This example shows how to use the VPN Setup Wizard to create a L2TP VPN
between a ZyWALL/USG and an Android 5.0 Mobile Device. The example instructs
how to configure the VPN tunnel between each site. When the VPN tunnel is
configured, each site can be accessed securely and allow traffic from L2TP
clients to go to the Internet.
ZyWALL/USG L2TP VPN with Android Mobile Devices Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: 4.25) and Android version (Firmware
Version: 5.0)