ZyXEL Communications USG210 - Set up the LAN Ipv6 Interface on the Zywall;Usg

722/749
www.zyxel.com
Set Up the LAN IPv6 Interface on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Ethernet > lan1.
Select Enable Interface and Enable IPv6. Type 2002:7a64:dcee:1::111/128 in the
IPv6 Address/Prefix Length field for the LAN1’s IP address.
Enable Router Advertisement. Then click Add in the Advertised Prefix Table to add
2002:7a64:dcee:1::/64. The LAN1 hosts will get the network prefix through the router
advertisement messages sent by the LAN1 IPv6 interface periodically. Click OK.
CONFIGURATION > Network > Interface > Ethernet > lan1 > General Settings