ZyXEL Communications USG210 - Setting up DHCP Option 60 on the CLI; Test DHCP Option 60

736/749
www.zyxel.com
Setting Up DHCP Option 60 on the CLI
Under the specific interface path, use these commands to:
Enable option 60
Router(config-if-wan1)# ip address dhcp option-60 {VCI_STRING}
Disable option 60
Router(config-if-wan1)# no ip address dhcp option-60
Test DHCP Option 60
To test the DHCP option 60 function, use a packet capture software to check if option
60 string exists in the DHCP discover message sent from the ZyWALL/USG WAN port.