404/749
CONFIGURATION > Network > Interface > VTI > vti1 > Connectivity Check
6 In the same screen, create a VTI for the VPN tunnel BO2. Be aware that the IP
address of this VTI must be in the same subnet as vti2 on USG1. In this example, the IP
address and subnet mask of vti2 on USG1 is 10.10.11.10 and 255.255.255.0 respectively.
The IP address of vti2 on USG2 must be in the subnet of 10.10.11.0/24. Enable the
connectivity check. Enter the IP address of vti2, which is configured on USG1.
CONFIGURATION > Network > Interface > VTI > Add
To Next Page
Loading...
