114/749
Now the rule is configured on the ZyWALL/USG. The Phase 1 rule settings appear in
the VPN > IPSec VPN > VPN Gateway screen and the Phase 2 rule settings appear
in the VPN > IPSec VPN > VPN Connection screen. Click Close to exit the wizard.
Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings > Wizard Completed
Go to Network > Routing > Policy Route to add a Policy Route to allow traffic from
Spoke_Branch_B to Spoke_Branch_A.
Click Create new Object and set Address to be the local network behind the
Spoke_Branch_A. Select Source Address to be the local network behind the
Spoke_Branch_B. Then, scroll down the Destination Address list to choose the
newly created Spoke_Branch_A_LOCAL address. Click OK.
Network > Routing > Policy Route
To Next Page
Loading...
