ZyXEL Communications USG310 - Set up the SIP ALG

412/749
www.zyxel.com
Set Up the SIP ALG
Go to CONFIGURATION > Network > ALG, and check “Enable SIP ALG”. Also, check
the “Enable SIP Transformations” if the SIP content which is needed to be transform.
Then click “Apply”.
CONFIGURATION > Network > ALG
Direct-media and Direct-signalling are activated after ZLD 4.25. We can use the CLI to
show the status. When the two options are yes, it will change the original sip alg
behavior.
direct-siginalling will expect incoming calls from register only.
direct-media will expect media streams between signalling endpoints only.
Enable direct-media and direct-signalling:
Router(config)# alg sip direct-signalling
Router(config)# alg sip direct-media
Disable direct-media and direct-signalling: