ZyXEL Communications USG310 - Test the Result

725/749
www.zyxel.com
CONFIGURATION > Network > Routing > Policy Route > IPv6 Configuration
Test the Result
Connect a computer to the ZyWALL/USG’s LAN1.
Enable IPv6 support on your computer. In Windows XP, you need to use the IPv6
install command in a Command Prompt. In Windows 7, IPv6 is supported by
default. You can enable IPv6 in the Control Panel > Network and Sharing Center >
Local Area Connection screen.
Your computer should get an IPv6 IP address (starting with 2002:7a64:dcee:1: for
this example) from the ZyWALL/USG.
Window 7 > cmd > ipconfig