ZyXEL Communications USG310 - Set up the Ipsec VPN Tunnel on the Sonicwall

220/749
www.zyxel.com
Set Up the IPSec VPN Tunnel on the SonicWALL
In the SonicWALL VPN > Settings > VPN Policies, click Add to create a new VPN
policy. Select Policy Type to be the Site to Site, select Authentication Method to be
the IKE using Preshared Secret. Type the ZyWALL/USG's WAN IP Address to be the
IPsec Primary Gateway Name or Address (in the example, 172.10.120.11).
In the IKE Authentication section, set the Shared Secret to be the same as your
ZyWALL/USG’s Pre-Shared Key. Then, set the Local IKE ID and the Peer IKE ID to
match your ZyWALL/USG’s VPN Gateway > Show Advanced Settings >
Authentication > Local ID Type and Peer ID Type.
VPN > Settings > VPN Policies > General