ZyXEL Communications USG310 - Test the Ipsec VPN Tunnel

224/749
www.zyxel.com
Test the IPSec VPN Tunnel
Go to ZyWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click
Connect on the upper bar. The Status connect icon is lit when the interface is
connected.
CONFIGURATION > VPN > IPSec VPN > VPN Connection
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up Time
and the Inbound(Bytes)/Outbound(Bytes) traffic.
MONITOR > VPN Monitor > IPSec
Go to SonicWALL VPN > VPN Settings > VPN Policies, the status green light is on.
VPN > VPN Settings > VPN Policies
Go to SonicWALL VPN > VPN Settings > Currently Active VPN Tunnels > VPN Tunnel
Statics to check Tunnel valid time, Bytes In (Incoming Data) and Bytes Out
(Outgoing Data).
VPN > VPN Settings > Currently Active VPN Tunnels