ZyXEL Communications USG310 - Set up the LAN Ipv6 Interface on the Zywall;Usg

712/749
www.zyxel.com
CONFIGURATION > Network > Interface > Ethernet > wan1
Set Up the LAN IPv6 Interface on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Ethernet > lan1.
Select Enable Interface and Enable IPv6. Select Enable Stateless Address
Auto-configuration (SLAAC). Select Enable Router Advertisement and click Add to
configure a network prefix for the LAN1 (2002:1111:1111:1111::/64 in this example).
Click OK.
Note: Your ISP or uplink router should enable router advertisement.