491/749
Setting Up the WAN IPv6 Interface
1. In the Configuration > Network > Interface > Ethernet screen, double-click the lan
interface in the IPv6 Configuration section.
2. The Edit Ethernet screen appears. Click Show Advanced Settings to display more
settings on this screen.
Select Enable Interface and Enable IPv6.
In the Address from DHCPv6 Prefix Delegation table, click Add and select the
DHCPv6 request object from the drop-down list, type ::1111:0:0:0:1/128 in the Suffix
Address field. (The combined address 2001:b050:2d:1111::1/128 will display as LAN1’s
IPv6 address after you click OK and come back to this screen again).
DHCPv6 Setting is N/A
Note: You can configure the IPv6 Address/Prefix Length field instead if the delegated
prefix is never changed.
3. In the Advertised Prefix from DHCPv6 Prefix Delegation table, click Add and select
the DHCPv6 request object from the drop-down list, type ::1111/64 in the Suffix
To Next Page
Loading...
