ZyXEL Communications USG60 - Chapter 7 Monitor; Overview; What You Can Do in this Chapter

ZyWALL/USG Series User’s Guide
181
CHAPTER 7
Monitor
7.1 Overview
Use the Monitor screens to check status and statistics information.
7.1.1 What You Can Do in this Chapter
Use the Monitor screens for the following.
•Use the System Status > Port Statistics screen (see Section 7.2 on page 182) to look at
packet statistics for each physical port.
•Use the System Status > Port Statistics > Graph View screen (see Section 7.2 on page 182)
to look at a line graph of packet statistics for each physical port.
•Use the System Status > Interface Status screen (Section 7.3 on page 185) to see all of the
ZyWALL/USG’s interfaces and their packet statistics.
•Use the System Status > Traffic Statistics screen (see Section 7.4 on page 187) to start or
stop data collection and view statistics.
•Use the System Status > Session Monitor screen (see Section 7.5 on page 190) to view
sessions by user or service.
•Use the System Status > IGMP Statistics screen (see Section 7.6 on page 191) to view
multicasting details.
•Use the System Status > DDNS Status screen (see Section 7.7 on page 192) to view the
status of the ZyWALL/USG’s DDNS domain names.
•Use the System Status > IP/MAC Binding screen (Section 7.8 on page 193) to view a list of
devices that have received an IP address from ZyWALL/USG interfaces with IP/MAC binding
enabled.
•Use the System Status > Login Users screen (Section 7.9 on page 193) to look at a list of the
users currently logged into the ZyWALL/USG.
•Use the System Status > Dynamic Guest screen (see Section 7.10 on page 194) to look at a
list of the guest user accounts, which are created automatically and allowed to access the
ZyWALL/USG’s services for a certain period of time.
•Use the System Status > Cellular Status screen (Section 7.11 on page 196) to check your
mobile broadband connection status.
•Use the System Status > UPnP Port Status screen (see Section 7.12 on page 199) to look at
a list of the NAT port mapping rules that UPnP creates on the ZyWALL/USG.
•Use the System Status > USB Storage screen (Section 7.13 on page 200) to view information
about a connected USB storage device.
•Use the System Status > Ethernet Neighbor screen (Section 7.14 on page 201) to view and
manage the ZyWALL/USG’s neighboring devices via Layer Link Discovery Protocol (LLDP).
•Use the Wireless > AP Information screen (Section 7.15.1 on page 202) to view information
on connected APs.