Chapter 43 System
ZyWALL/USG Series User’s Guide
828
1 Click System > Date/Time.
2 Select Manual under Time and Date Setup.
3 Enter the ZyWALL/USG’s time in the New Time field.
4 Enter the ZyWALL/USG’s date in the New Date field.
5 Under Time Zone Setup, select your Time Zone from the list.
6 As an option you can select the Enable Daylight Saving check box to adjust the ZyWALL/USG
clock for daylight savings.
7 Click Apply.
To get the ZyWALL/USG date and time from a time server
1 Click System > Date/Time.
2 Select Get from Time Server under Time and Date Setup.
3 Under Time Zone Setup, select your Time Zone from the list.
4 As an option you can select the Enable Daylight Saving check box to adjust the ZyWALL/USG
clock for daylight savings.
5 Under Time and Date Setup, enter a Time Server Address (Table 347 on page 827).
6 Click Apply.
43.5 Console Port Speed
This section shows you how to set the console port speed when you connect to the ZyWALL/USG via
the console port using a terminal emulation program.
Click Configuration > System > Console Speed to open the Console Speed screen.
Figure 574 Configuration > System > Console Speed
To Next Page
Loading...
