Chapter 10 Interfaces
ZyWALL/USG Series User’s Guide
327
10.8.2 Bridge Add/Edit
This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP
settings, and connectivity check for each bridge interface. To access this screen, click the Add or
Edit icon in the Bridge Summary screen. The following screen appears.
Object References Select an entry and click Object Reference to open a screen that shows which
settings use the entry. See Section 10.3.4 on page 286 for an example.
# This field is a sequential value, and it is not associated with any interface.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Name This field displays the name of the interface.
IP Address This field displays the current IP address of the interface. If the IP address is 0.0.0.0,
the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (STATIC) or
dynamically assigned (DHCP). IP addresses are always static in virtual interfaces.
Member This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface. It
is blank for virtual interfaces.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
Table 117 Configuration > Network > Interface > Bridge (continued)
LABEL DESCRIPTION
To Next Page
Loading...
