Chapter 45 File Manager
ZyWALL/USG Series User’s Guide
907
45.4 The Shell Script Screen
Use shell script files to have the ZyWALL/USG use commands that you specify. Use a text editor to
create the shell script files. They must use a “.zysh” filename extension.
Click Maintenance > File Manager > Shell Script to open the Shell Script screen. Use the
Shell Script screen to store, name, download, upload and run shell script files. You can store
multiple shell script files on the ZyWALL/USG at the same time.
Note: You should include write commands in your scripts. If you do not use the write
command, the changes will be lost when the ZyWALL/USG restarts. You could use
multiple write commands in a long script.
Figure 641 Maintenance > File Manager > Shell Script
Each field is described in the following table.
Table 383 Maintenance > File Manager > Shell Script
LABEL DESCRIPTION
Rename Use this button to change the label of a shell script file on the ZyWALL/USG.
You cannot rename a shell script to the name of another shell script in the ZyWALL/USG.
Click a shell script’s row to select it and click Rename to open the Rename File screen.
Figure 642 Maintenance > File Manager > Shell Script > Rename
Specify the new name for the shell script file. Use up to 25 characters (including a-zA-Z0-
9;‘~!@#$%^&()_+[]{}’,.=-).
Click OK to save the duplicate or click Cancel to close the screen without saving a
duplicate of the configuration file.
Remove Click a shell script file’s row to select it and click Remove to delete the shell script file from
the ZyWALL/USG.
A pop-up window asks you to confirm that you want to delete the shell script file. Click OK
to delete the shell script file or click Cancel to close the screen without deleting the shell
script file.
To Next Page
Loading...
