ZyWALL/USG Series User’s Guide
241
CHAPTER 9
Wireless
9.1 Overview
Use the Wireless screens to configure how the ZyWALL/USG manages the Access Points (APs) that
are connected to it.
9.1.1 What You Can Do in this Chapter
•Use the Controller screen (Section 9.2 on page 241) to set how the ZyWALL/USG allows new
APs to connect to the network.
•Use the AP Management screens (Section 9.3 on page 242) to manage all of the APs connected
to the ZyWALL/USG.
•Use the MON Mode screen (Section 9.4 on page 253) to assign APs either to the rogue AP list or
the friendly AP list.
•Use the Auto Healing screen (Section 9.5 on page 255) to extend the wireless service coverage
area of the managed APs when one of the APs fails.
•Use the RTLS screen (Section 9.6 on page 256) to allow managed APs with battery-powered Wi-
Fi tags be part of Ekahau RTLS (Real Time Location Service). RTLS can track the location of APs
managed by the ZyWALL/USG to create maps, alerts, and reports.
9.2 Controller Screen
Use this screen to set how the ZyWALL/USG allows new APs to connect to the network. Click
Configuration > Wireless > Controller to access this screen.
Figure 198 Configuration > Wireless > Controller
To Next Page
Loading...
