NWA/WAC/WAX Series User’s Guide
13
CHAPTER 1
Introduction
1.1 Overview
This User’s Guide covers the models listed in the following table. They can be managed in one of the
following methods: remote management through Nebula Control Center (NCC) or an AP Controller
(AC) such as the ZyWALL ATP, or local management in Standalone Mode. Each Zyxel Device runs in
standalone mode by default, but it is recommended to use NCC management if it is available for your
device.
For more information about Access Point (AP) management, see Section 2.1 on page 30.
When two or more APs are interconnected, this network is called a Wireless Distribution System (WDS).
See Section 1.3.2 on page 24 for more information on root and repeater APs and how to set them up.
The screens you see in the web configurator may be different depending on the Zyxel Device model
you’re using.
NCC, AC or Standalone
(NebulaFlex PRO)
NCC or Standalone
(NebulaFlex)
AC or Standalone
• NWA5123-AC HD • NWA1123-ACv2 • NWA5123-AC
• WAC6103D-I • NWA1123-AC PRO • WAC5302D-S
• WAC6303D-S • NWA1123-AC HD
• WAC6502D-E • NWA1302-AC
• WAC6502D-S • NWA110AX
• WAC6503D-S • NWA210AX
• WAC6552D-S • NWA220AX-6E
• WAC6553D-E • NWA1123ACv3
• WAC500
• WAC500H
• WAC5302D-Sv2
• WAX510D
• WAX610D
• WAX620D-6E
• WAX630S
• WAX640S-6E
• WAX650S
To Next Page
Loading...
