Chapter 27 Maintenance
NWA/WAC/WAX Series User’s Guide
263
Figure 167 Maintenance > Diagnostics > Remote Capture
Figure 168 Maintenance > Diagnostics > Remote Capture (Zyxel Device that supports Wireless Remote
Capture)
The following table describes the labels in this screen.
27.5 View Log
The NCC periodically gathers log files from the devices being managed by it. Before the NCC pulls logs
from the Zyxel Device or when the Zyxel Device is disconnected from the NCC, you can use this screen
to view its current log messages. To access this screen, click Maintenance > Log.
Note: When a log reaches the maximum number of log messages, new log messages
automatically overwrite existing log messages, starting with the oldest existing log
message first.
Events that generate an alert (as well as a log message) display in red. Regular logs display in black.
Click a column’s heading cell to sort the table entries by that column’s criteria. Click the heading cell
again to reverse the sort order.
Table 109 Maintenance > Diagnostics > Remote Capture
LABEL DESCRIPTION
Server Port Enter the number of the server port you want the packet analyzer to connect to in order to
capture traffic going through the Zyxel Device. The default port number is 2002.
Start Click this button to allow the packet analyzer to start capturing traffic going through the Zyxel
Device.
Stop Click this button to stop the packet analyzer from capturing traffic going through the Zyxel
Device.
To Next Page
Loading...
