Chapter 2 AP Management
NWA/WAC/WAX Series User’s Guide
37
Figure 14 Password Prompt
The following table describes the icons numbered from left to right in the ZON Utility screen.
Table 8 ZON Utility Icons
ICON DESCRIPTION
1 IP Configuration Change the selected device’s IP address.
2 Renew IP Address Update a DHCP-assigned dynamic IP address.
3 Reboot Device Use this icon to restart the selected device(s). This may be useful when troubleshooting
or upgrading new firmware.
4 Reset Configuration to
Default
Use this icon to reload the factory-default configuration file. This means that you will
lose all previous configurations.
5 Locator LED Use this icon to locate the selected device by causing its Locator LED to blink.
6 Web GUI Use this to access the selected device Web Configurator from your browser. You will
need a username and password to log in.
7 Firmware Upgrade Use this icon to upgrade new firmware to selected device(s) of the same model. Make
sure you have downloaded the firmware from the Zyxel website to your computer and
unzipped it in advance.
8 Change Password Use this icon to change the admin password of the selected device. You must know
the current admin password before changing to a new one.
9 Configure Controller
Discovery and NCC
Discovery
The option is available if the selected device supports AP controller discovery or
Nebula Control Center (NCC) discovery. You must have Internet access to use this
feature. Use this icon on the selected device to enable or disable the:
• AP controller discovery feature
• Nebula Control Center (NCC) discovery feature
If the feature is enabled, the selected device will try to connect to the AP controller/
NCC. If the selected device has successfully connected to an AP controller, it will
change to the AP controller managed mode. If the selected device has successfully
connected to the NCC and is registered on the NCC, it will change to the Nebula
cloud mode.
10 ZAC Use this icon to run the Zyxel AP Configurator of the selected AP.
11 Clear and Rescan Use this icon to clear the list and discover all devices on the connected network again.
12 Save Configuration Use this icon to save configuration changes to permanent memory on a selected
device.
13 Settings Use this icon to select a network adapter for the computer on which the ZON utility is
installed, and the utility language.
To Next Page
Loading...
