Chapter 3 Hardware
NWA/WAC/WAX Series User’s Guide
48
Green Steady On The Zyxel Device is ready for use, the Zyxel Device’s wireless
interface is activated, and/or WiFi clients are connected to
the Zyxel Device in full power mode (see Table 28 on page
76).
Amber Steady On The Zyxel Device is ready for use in limited power mode (see
Table 28 on page 76), the Zyxel Device’s wireless interface is
activated, and/or WiFi clients are connected to the Zyxel
Device.
Note: WiFi networks on the WAX650S are turned off
automatically when it is connected to a device
that supplies power using IEEE 802.3af PoE.
Bright Blue Steady On The Zyxel Device’s wireless interface is activated, but there
are no WiFi clients connected when it is in full power mode
(see Table 28 on page 76).
White Slow Blinking (On for
100ms per second)
Locator LED is on. It switches off automatically after the
configured amount of time (1-60 min). Default duration is 10
minutes.
Note: The color of the white LED may have slight
differences (for example, very light purple) on
different models.
Blue Slow Blinking (Blink for 1
time, Off for 1 second)
The Zyxel Device is performing a Channel Availability Check
(CAC) with Dynamic Frequency Selection (DFS) to monitor a
channel for radar signals.
Red On The Zyxel Device failed to boot up or is experiencing system
failure.
Fast Blinking (On for 50
milliseconds, Off for 50
milliseconds)
The Zyxel Device is undergoing firmware upgrade.
Slow Blinking (Blink for 3
times, Off for 3 seconds)
The uplink of the Zyxel Device is disconnected.
Table 13 WAC500, WAC500H, NWA1123ACv3, NWA110AX, NWA210AX, WAX510D, WAX610D, WAX630S
and WAX650S LED (continued)
COLOR STATUS DESCRIPTION
To Next Page
Loading...
